Disassembly - Part 5

1972 Porsche 914

Pulled both doors off. Generally went well. Some missing hardware. List of known issues...

	No vapor shield so fiber boards are warped.
	Missing seals on both sides of windows
	Missing screws to attach boards to door
	Maybe some missing hardware for bottom of front rail on one of the doors?
	Driver door exterior handle has issues with bolt spun in pot metal. New handle needed?
	Need to drill out holes and install passenger mirror.
	Need to get passenger mirror
	Some small rust spots on seals around door.
	Rollers for window rails can be easy to loose.

Photos...

Right door hinges.

Right door complete.

Note the following...

	Rubber grommet/sleeve for rod from interior handle to latch. Are those cheap enough to get new?
	Rubber grommet for bottom of crank track.
	Adjuster screw for front rail was different on each side. Which side is correct?

Note the following...

	Plastic sockets that allow fiber board to snap into place.
	Seal
	Screw for door handle.

Note the following...

	Rubber grommet for window crank track. Track just slides into grommet. I think grommet has "D" shape.
	Adjustment screw for window rail.

Note the following...

Same screws that hold the front rail and window in lace. One closest to the front is just a metal bar that is attached to rubber seal on window?

Send questions or comments about this site to webmaster@zyyz.com.
Copyright © 2000 zyyz.com
Last modified: September 05, 2006